|
Post by garrettwp on Aug 15, 2014 11:10:51 GMT -5
I picked up a used USP-1 preamp and just took delivery of some emotiva equipment direct from emotiva themselves. I'm running into a small issue, when changing the source on the USP-1, the XPA-200 goes into a fault mode with the channel 1 flashing. I have to shut the XPA-200 off and back on to correct itself. Anyone experience this? Other than that it plays and sounds great. I checked to makes sure all connections are secure and not touching each other.
- Garrett
|
|
|
Post by knucklehead on Aug 15, 2014 11:18:10 GMT -5
If you have other interconnects try swapping them out and see if that helps. It might be a cable problem. Might be the amp. Trial and error.
|
|
|
Post by jmilton on Aug 15, 2014 11:23:59 GMT -5
Don't neglect to check the speaker cable going out from the amp. Almost every time I had the fault light come on, it was the speaker cable.
|
|