|
Post by 405x5 on Apr 3, 2018 20:12:42 GMT -5
“Just a quick update. I haven’t been able to work on this project as much as I’ve wanted due to work. So, powering off the analog board is not going to be as simple as attaching a relay. There must be a signal from the DAC to the analog board to turn on and off because pulling the power cord gets a little “pop” and plugging the power back in does not get audio. You need to reset the system, then everything works again. The next step is to figure out the signal (and pins) during the startup and shut down modes and trigger the analog board on and off properly. Once that procedure is figured out, turning off the analog power supply is next and standby will be about as power efficient as possible.” Please let me know before you plug the thing in so I can stand across the street.
|
|
|
Post by wilburthegoose on Apr 4, 2018 7:11:45 GMT -5
Ironically, this project is a waste of time.
|
|
|
Post by 405x5 on Apr 4, 2018 8:01:24 GMT -5
Just now I noticed that.. For My XMC-1, centre channel sound also delivering equally from both fronts.. anyone can suggest me to rectify.. Also tried resetting, restore settings also.. You’re in one of the stereo modes, sounds like. Have you set the default modes for your inputs? Bill
|
|
|
Post by rbk123 on Apr 4, 2018 8:32:02 GMT -5
Ironically, this project is a waste of time.
|
|
|
Post by 405x5 on Apr 4, 2018 8:54:32 GMT -5
|
|
KeithL
Administrator
Posts: 9,937
|
Post by KeithL on Apr 4, 2018 10:48:32 GMT -5
It sounds like you've got a Stereo PCM input signal being decoded by PLIIx. If that's the case, you need to change the configuration on your SOURCE DEVICE to output real surround sound. Just now I noticed that.. For My XMC-1, centre channel sound also delivering equally from both fronts.. anyone can suggest me to rectify.. Also tried resetting, restore settings also.. You’re in one of the stereo modes, sounds like. Have you set the default modes for your inputs? Bill
|
|
|
Post by panchakshari on Apr 5, 2018 0:12:13 GMT -5
Thanks for advice.. I will try today itself..
|
|
|
Post by panchakshari on Apr 6, 2018 7:31:21 GMT -5
Thanks for advice.. I will try today itself.. My player was oppo bdp-103 Kindly suggest me settings.. thanks
|
|
|
Post by 405x5 on Apr 6, 2018 7:45:41 GMT -5
Thanks for advice.. I will try today itself.. My player was oppo bdp-103 Kindly suggest me settings.. thanks The player should output “bitstream” to the XMC
|
|