|
Post by e30abrio on Jan 22, 2020 18:30:35 GMT -5
Sorry to invade this thread but I need help with a new to me used MPS-2 I received Monday. It has one module with a blown fuse and I can't figure out what fuse to get to replace it. I searched the manual for the MPS-1 I was told was the same as the 2 when I asked Emotiva for a manual and the only reference to fuse spec I found was TL15AL type rated a 15A, 250 V. for the main power supply. The fuse in question is small, has what looks like a spring inside, says 6A, 250v but nowhere can I find what I need to buy. Any help is greatly appreciated. Attachments:
|
|
|
Post by e30abrio on Jan 23, 2020 10:00:43 GMT -5
In case anyone else needs this, I got this from Emotiva:
Main Chassis Fuses (All Fuses Are Slow Blow 250 Volt)
For 120 Volt Use F1 = T15A 5mm x 20mm (Rear Panel) F2 = T15A 5mm x 20mm (Rear Panel) F3 = T160mA 5mm x 20mm (Internal Side Panel)
For 230 Volt Use F1 = T7A 5mm x 20mm (Rear Panel) F2 = T7A 5mm x 20mm (Rear Panel) F3 = T100mA 5mm x 20mm (Internal Side Panel)
EPM Modules (EPM-2150 & EPM-300)
For 120 Volt Use F = T6A 5mm x 20mm
For 230 Volt Use F = T3.15A 5mm x 20mm
Voltage Conversion
On Main Chassis (on bottom) Change voltage selector switch to desired voltage
On EPM Modules Change voltage selector switch to desired voltage
|
|
|
Post by leonski on Jan 23, 2020 16:36:04 GMT -5
couldn't just read the fuse? I suspect a 3amp will do just fine, since sourcing a 3.15amp fuse might be a problem?
|
|
|
Post by e30abrio on Jan 23, 2020 16:40:02 GMT -5
I did read the fuse. It says 6A 250V.
It does not say fast or slow blow. I had to order it and didn't want to order, wait get the wrong one and start over.
|
|