|
Post by magnumpraw on Sept 21, 2018 17:29:19 GMT -5
Soooo. I just downloaded and initiated the update for the 5.3beta 1 firmware on my XMC-1. It was previously on 5.1. The firmware process seemed to go fine till it got to a point where it would read: "HDMI Failed" and then: "Reboot" a progress bar would then fill up with the display reading: "HDMI Failed" and then: "Reboot" I let it stay in this loop for a good 3 mins (about 30 times through this cycle) . The front power button wouldn't respond, so I eventually pulled the plug. Now when the unit starts up, it reads: "err: init HDSB82" and just stays there. Any ideas, or do I now have a brick?
|
|
geebo
Emo VIPs
"Too bad that all the people who know how to run the country are driving taxicabs and cutting hair"
Posts: 24,161
|
Post by geebo on Sept 21, 2018 20:16:45 GMT -5
Soooo. I just downloaded and initiated the update for the 5.3beta 1 firmware on my XMC-1. It was previously on 5.1. The firmware process seemed to go fine till it got to a point where it would read: "HDMI Failed" and then: "Reboot" a progress bar would then fill up with the display reading: "HDMI Failed" and then: "Reboot" I let it stay in this loop for a good 3 mins (about 30 times through this cycle) . The front power button wouldn't respond, so I eventually pulled the plug. Now when the unit starts up, it reads: "err: init HDSB82" and just stays there. Any ideas, or do I now have a brick? I don't think your going to be able to do anything for that. Mine had to go back to Emotiva when that happened to me. In my case I had old and new firmware on the same thumbdrive and think that's what caused it. Was 5.3 the only thing on your thumb drive?
|
|
|
Post by magnumpraw on Sept 23, 2018 18:10:01 GMT -5
Well, that’s a bummer. Yes I reformatted the drive just to make sure there was nothing else on there.
|
|
geebo
Emo VIPs
"Too bad that all the people who know how to run the country are driving taxicabs and cutting hair"
Posts: 24,161
|
Post by geebo on Sept 23, 2018 20:18:30 GMT -5
Well, that’s a bummer. Yes I reformatted the drive just to make sure there was nothing else on there. Let us know what Emo says.
|
|
|
Post by magnumpraw on Nov 2, 2018 12:57:44 GMT -5
I did have to send it in, which took a while, but it is back and working properly now. Yay!!!!
|
|
geebo
Emo VIPs
"Too bad that all the people who know how to run the country are driving taxicabs and cutting hair"
Posts: 24,161
|
Post by geebo on Nov 2, 2018 14:29:52 GMT -5
I did have to send it in, which took a while, but it is back and working properly now. Yay!!!! Sorry you had to send it in but glad you got it back and working again. FWIW, mine has been flawless since I got it back.
|
|