sealman
Minor Hero
You shouldn't have decorated your saloon with my friend!
Posts: 78
|
Post by sealman on Mar 11, 2020 18:42:51 GMT -5
The title pretty much says it all. Was/am? updating to 1.9 and it seemed to be progressing just fine. After 7-10 minutes or so the progress bars went away and I am stuck on the "please wait" message on the display.
It has been approx 20 minutes now since the please wait message appeared. Any thoughts?
|
|
|
Post by creimes on Mar 11, 2020 19:57:58 GMT -5
The title pretty much says it all. Was/am? updating to 1.9 and it seemed to be progressing just fine. After 7-10 minutes or so the progress bars went away and I am stuck on the "please wait" message on the display. It has been approx 20 minutes now since the please wait message appeared. Any thoughts? Other people seem to have had this issue and they turned it off and back on and it was good.
|
|
sealman
Minor Hero
You shouldn't have decorated your saloon with my friend!
Posts: 78
|
Post by sealman on Mar 12, 2020 8:25:53 GMT -5
Well I (as others have done) switched mine off via back panel rocker switch and then back on after removing the usb stick. It powered up and went to the "please wait" screen where 2-3 progress bars just like the update had appeared and then it was all normal after that.
Firmware version now shows 1.9 so I guess all is good.
|
|
sealman
Minor Hero
You shouldn't have decorated your saloon with my friend!
Posts: 78
|
Post by sealman on May 20, 2020 13:50:55 GMT -5
I updated my drivers recently to the current version and the install went without a hitch this time! However the thumb drive that Emotiva sent me with the XMC2 was not even recognized this time. I tried re downloading the drivers again and no luck. I even tried deleting the drivers and reformatting the drive again with zero luck. But as I had no shortage of extra drives laying around I tried one and it took it first try.
So now I am wondering if it was the drives fault for my last drive update issues.
|
|