|
Post by red5ive on Jul 20, 2020 17:07:29 GMT -5
I currently have an RPA-2 powering my mains, and a Gen 1 XPA-5 powering my center, rear surrounds, and front overhead channels (processor is a Yamaha CX-A5200). I'm looking to add a pair of rear overheads for a 5.2.4. Atmos setup. I'll be going with the SVS Prime Elevation Speaker. I think a BasX A-150 should fit the bill, but just wanted to check if anyone might have any input? Edit: Been a while since I've read this forum and I just realized my sig needs updating. Yikes!
|
|
|
Post by mshump on Jul 20, 2020 17:24:25 GMT -5
That should be fine.
Mark
|
|
|
Post by gus4emo on Jul 20, 2020 21:06:19 GMT -5
I currently have an RPA-2 powering my mains, and a Gen 1 XPA-5 powering my center, rear surrounds, and front overhead channels (processor is a Yamaha CX-A5200). I'm looking to add a pair of rear overheads for a 5.2.4. Atmos setup. I'll be going with the SVS Prime Elevation Speaker. I think a BasX A-150 should fit the bill, but just wanted to check if anyone might have any input? Edit: Been a while since I've read this forum and I just realized my sig needs updating. Yikes! The A150 is awesome, I'm using 2 for height and wides...
|
|
|
Post by red5ive on Jul 21, 2020 11:27:03 GMT -5
Thanks for the input. I was mostly concerned with integrating a lower power amp with the RPA-2 and XPA-5 Gen 1. Not that I doubt the BasX line's capabilities (I have a BasX A700 in the mancave), but I was just wondering if I should go with something with more power like the A-300, or even replace my XPA-5 with an XPA-7.
Anyway, I went ahead and ordered the A150. I do like the 2RU, it'll take up the gap I have in my rack perfectly.
|
|
|
Post by creimes on Jul 21, 2020 11:42:46 GMT -5
I was gonna say A-150 as well
|
|
|
Post by red5ive on Jul 21, 2020 13:54:29 GMT -5
Well scratch that. My conscience got the best of me. I called Emotiva and had them cancel the order and I ordered an A-300 instead. Double the power for $100 more, why not?
|
|