|
Post by howard1818 on Sept 3, 2020 13:53:42 GMT -5
What inputs and outputs do I use for cabling a UMC-1 to a tube amp, TV and Blu Ray player? I can get the Blu Ray to play but not through my speakers. I also have my music on hard drives through a computer that HDMI goes to the TV and will play there but I'm just not getting anything though my speakers. Thanks
|
|
|
Post by sockemdog on Sept 3, 2020 23:45:21 GMT -5
What inputs and outputs do I use for cabling a UMC-1 to a tube amp, TV and Blu Ray player? I can get the Blu Ray to play but not through my speakers. I also have my music on hard drives through a computer that HDMI goes to the TV and will play there but I'm just not getting anything though my speakers. Thanks Don’t use the HDMI ports for anything on the UMC-1. Only digital/analog otherwise you’re asking for trouble. Don’t waste your time with HDMI if that’s what you’re trying to get to work. Trust all of us that have owned a UMC-1. Connect your Blu-ray output with digital cables through coax or toslink to the UMC-1. Then connect your Blu-ray HDMI output directly to your TV. Then UMC-1 L/R front analog outs to tube amp (I assume that’s what you are using it for). Hope that helps. Brad
|
|
|
Post by howard1818 on Sept 4, 2020 8:19:14 GMT -5
thanks I will give that a shot. I have done the HDMI from the tv to the UMC and I am assuming the amp to the 7.1 outs too bad to hear about the HDMI that was why I bought this used unit was because of all of those slots
|
|