zerafa
Sensei
running in a LH Labs Pulse X
Posts: 147
|
Post by zerafa on Nov 5, 2020 12:11:02 GMT -5
I must be missing something, but is there a thread or resource that i can look at the differences between these different units? I can not find a side by side comparison to understand the differences
There seems to be very little actually different between the different models.
I need to use my upgrade card, and change out my XMC-1 (original spec), and not really sure which unit is the best approach.
I have a dedicated room, with the following:
XMC-1
XPA2 x 2 (powering the fronts in a bi-amped mode) XPA-5 (powering the center, backs and surrounds) two smaller stereo amps (A100 i think)
4 x ERT 8.3 (fronts and sides) 3 x ERM 6.3 (center and rears) 4 x ER ?? (ceiling speakers - sitting in the box) 2 big sub woofers (power X - dual back to back 15inch drivers - S30)
I would love some good advice of how to reconfigure this into a ATMOS set up... with a newer generation processor.
Thanks for your help, and advice as to the differences between the different processors.
Matt
|
|
stiehl11
Emo VIPs
Give me available light!
Posts: 7,261
|
Post by stiehl11 on Nov 5, 2020 13:04:30 GMT -5
The short way of looking at this is what is left off as you go down the ladder of the Gen 3 Processors. RMC-1 has everything, RMC-1L is just like the RMC-1 minus the expansion bays in back, and the XMC-2 subtracts the individual DACs on everything other than the front stage (L,C,R), the dual display screens, the central encoder (uses buttons like the XMC-1) and the upgraded hardware on the back.
|
|
|
Post by ttocs on Nov 5, 2020 13:15:31 GMT -5
|
|