|
|
Post by johnraiders on Dec 19, 2020 14:42:52 GMT -5
What can cause the MAC address to change ?
Mine went in for a fault and its come back with a different MAC address, all the inputs are labeled differently and it wont read my memory stick.
Can memory stick settings only be loaded from unit that created it ?
Thanks
|
|
|
|
Post by johnraiders on Dec 19, 2020 16:21:19 GMT -5
And Dirac has no license, so I think swapped XMC-2
|
|
|
|
Post by ttocs on Dec 19, 2020 16:56:09 GMT -5
What can cause the MAC address to change ? Mine went in for a fault and its come back with a different MAC address, all the inputs are labeled differently and it wont read my memory stick. Can memory stick settings only be loaded from unit that created it ? Thanks Sounds like the board with the chip that contains the MAC address was changed out. I can't address the memory stick issue, but the Dirac License is tied directly to the MAC address, so the new MAC will need to be registered. |
|
|
|
Post by johnraiders on Dec 19, 2020 18:22:46 GMT -5
What can cause the MAC address to change ? Mine went in for a fault and its come back with a different MAC address, all the inputs are labeled differently and it wont read my memory stick. Can memory stick settings only be loaded from unit that created it ? Thanks Sounds like the board with the chip that contains the MAC address was changed out. I can't address the memory stick issue, but the Dirac License is tied directly to the MAC address, so the new MAC will need to be registered. Ok on board. The overall settings are completely different, all the HDMI slots named differently, display defaults to off. Will try another factory reset tomorrow. Thanks |
|
|
|
Post by rbk123 on Dec 19, 2020 18:26:56 GMT -5
Probably just sent you a new or refurb to get you going while they fix it and put it with the refurbs.
|
|
|
|
Post by johnraiders on Dec 19, 2020 19:57:54 GMT -5
Factory reset, then i try and load settings, it doesnt look at USB, it was trying to load a corrupted internal file. So Factory reset, saved those settings, now the corrupted one has gone.
But it doesnt recognise USB, will try reformat..
Re-registered MAC address for Dirac.
So at least I'm further forward...
|
|
LCSeminole
Global Moderator 
Res firma mitescere nescit.
Posts: 20,495
|
Post by LCSeminole on Dec 19, 2020 20:56:17 GMT -5
Have you tried another USB stick? Sometimes for whatever reason these processors are finicky about recognizing USB sticks even if they are the same brand/model USB stick.
|
|
|
|
Post by johnraiders on Dec 20, 2020 2:55:44 GMT -5
Reformatted USB to Fat32, cant see it in front or rear slot. Tried 2 different sticks, including one from Emotiva.
Last hope that as Dirac isn't registered and settings include a Dirac file.....will see when MAC address gets known to Dirac.
|
|
