|
Post by vmbray on Jan 22, 2021 19:12:51 GMT -5
Posting what I have in case it's useful to someone, and to get some help on some commands that aren't documented. Roomie has an old command set that is missing some inputs and the surround modes aren't updated, and I added some sub boost buttons (this is the fun part for movies if you're not using bass eq or for random demos). Modes that I don't have working are all stereo and direct. Have tried a few commands to get those modes working but haven't stumbled on the right commands, assuming they are supported. Edit: found the updated command set and fixed all_stereo. Direct wasn't working for some reason so I replaced the command with a copy of the dolby command and changed it and now it works. Added trims for all the available speakers, and got it all to fit on one page of commands in the remote. Emotiva-G3P Zone 1-udp.zip (1.18 KB)
|
|
|
Post by vmbray on Jan 23, 2021 8:34:33 GMT -5
Couple screenshots from Roomie on my phone, the xmc device is in the middle, you can see TiVo above and atlona below but xmc is what’s between them. Aside from getting feedback working this works great with the xmc.
|
|
|
Post by jbrunwa on Jul 21, 2021 14:45:16 GMT -5
Couple screenshots from Roomie on my phone, the xmc device is in the middle, you can see TiVo above and atlona below but xmc is what’s between them. Aside from getting feedback working this works great with the xmc. Thanks for posting. I just downloaded roomie remote and I’m looking into switching over to ip control from Logitech harmony. Do you know if there is an official ip control protocol document for the G3Ps?
|
|
|
Post by vmbray on Jul 21, 2021 16:47:12 GMT -5
Do you know if there is an official ip control protocol document for the G3Ps? I don’t think it’s been updated but there is a doc floating around here somewhere. Lmk if you don’t find it and I’ll send what I have.
|
|