|
XMC-1
Mar 4, 2021 14:43:57 GMT -5
Post by sgtmick67 on Mar 4, 2021 14:43:57 GMT -5
Last night I watched a Blu-ray movie in surround sound. For some reason all the speakers worked except for my SVS sub, which would not produce any sound. It was on but no sound. I did a factory reset of the XMC-1 but my sub still won't come on. Any thoughts, Bob
|
|
cawgijoe
Emo VIPs
"We made too many of the wrong mistakes." - Yogi Berra
Posts: 4,903
|
XMC-1
Mar 4, 2021 15:14:42 GMT -5
Post by cawgijoe on Mar 4, 2021 15:14:42 GMT -5
Last night I watched a Blu-ray movie in surround sound. For some reason all the speakers worked except for my SVS sub, which would not produce any sound. It was on but no sound. I did a factory reset of the XMC-1 but my sub still won't come on. Any thoughts, Bob My previous sub which was SVS had an automatic signal "sensor" and sometimes it would not sense anything and not come on. That was with a Denon receiver and later with an XMC-1. I would have to turn the sub off and on to get it to work.
|
|
|
Post by doc1963 on Mar 4, 2021 16:49:06 GMT -5
Last night I watched a Blu-ray movie in surround sound. For some reason all the speakers worked except for my SVS sub, which would not produce any sound. It was on but no sound. I did a factory reset of the XMC-1 but my sub still won't come on. Any thoughts, Bob What is the output level setting going out of your XMC-1 to your sub...? If too far in the negative, and as cawgijoe mentions, the " auto signal detection" system found on most subwoofers will not trigger. If this is the case, reduce the gain on your subwoofer a little and then increase the subwoofer output voltage (level) from your XMC-1. That should take care of it...
|
|
|
Post by sgtmick67 on Mar 5, 2021 10:58:39 GMT -5
I found the problem. Some how the RCA cable became disconnected from the back of the XMC-1. Duh..........Thanks for help Guys
|
|
|
Post by JNieves on Mar 5, 2021 12:24:41 GMT -5
I have also experienced the fact that a disconnected cable results in greatly decreased subwoofer output.
|
|
cawgijoe
Emo VIPs
"We made too many of the wrong mistakes." - Yogi Berra
Posts: 4,903
|
XMC-1
Mar 5, 2021 12:42:39 GMT -5
Post by cawgijoe on Mar 5, 2021 12:42:39 GMT -5
I found the problem. Some how the RCA cable became disconnected from the back of the XMC-1. Duh..........Thanks for help Guys This is the kind of resolution we like to see!
|
|