yetis
Minor Hero
Posts: 16 
|
Post by yetis on Nov 6, 2021 12:42:16 GMT -5
Hi,
Has anyone had any success with IP control of a XMC2 or RMC? I use the IP control exclusively with my Savant setup and want to know if the existing ip commands will carry over? I really am set and forget and only use as surround processor, so just use power, input and volume, most of the time.
Thank you
|
|
|
|
Post by millst on Nov 6, 2021 13:05:41 GMT -5
|
|
yetis
Minor Hero
Posts: 16
|
Post by yetis on Feb 20, 2022 14:36:55 GMT -5
Following up here. The App and associated IP control works, but with all the extra outputs, it doesn't fully work for the RMC. Case in point is the coax input. For the XMC-1, the coax inputs were in tandem with an HDMI input. So if I picked input 3, I would get coax 3 if there wasn't an HDMI. Now that doesn't work, as their all independent inputs on the unit!
|
|
|
|
Post by AudioHTIT on Feb 20, 2022 15:50:11 GMT -5
Following up here. The App and associated IP control works, but with all the extra outputs, it doesn't fully work for the RMC. Case in point is the coax input. For the XMC-1, the coax inputs were in tandem with an HDMI input. So if I picked input 3, I would get coax 3 if there wasn't an HDMI. Now that doesn't work, as their all independent inputs on the unit! I think the situation is the same as it has been, the API is there, but to my knowledge no one has written an App to take full advantage of the IP command set. |
|
