|
|
Post by tbrown7777 on Aug 24, 2022 19:59:00 GMT -5
Anyone had this issue? Im assuming there is a setting I have wrong?
Thanks,
Tim
|
|
|
|
Post by ttocs on Aug 24, 2022 20:21:26 GMT -5
It just needs a Cold Boot.
Switch off the rear power switch for a few minutes.
|
|
|
|
Post by 405x5 on Aug 25, 2022 7:05:20 GMT -5
Did you replace your monitor or change the aspect ratio on it since using with your current processor? (maybe?)
You’ve taken me down a “memory lane” trip with an OSD issue…..
My pre HDMI Sunfire Processor. …..Had all BUT HDMI, and when I “upgraded” all to “component video”, display the OSD became unavailable!
Then I figured out if I kept an old VCR in the system, I could select VCR SOURCE and run the OSD Thru the antenna connection! (LOL) necessity is THAT mother of invention!
|
|
|
|
Post by 405x5 on Aug 25, 2022 7:28:14 GMT -5
…..There was yet one more part to that story…. I ended up needing to make that a passive antenna connection. I used the connection with RG 59 and with the cable active, the cable signal overloaded the circuit in the vcr and again, I lost display. Running it with the cable company out of the loop took care of that.
|
|
|
|
Post by tbrown7777 on Aug 28, 2022 12:42:22 GMT -5
Unplugging the unit and restarting brings it back. It seems to only last a week or so and it goes back to being scrambled. How did you figure out you needed to add an antenna? That's getting down the list!
|
|
|
|
Post by 405x5 on Aug 28, 2022 13:19:36 GMT -5
Unplugging the unit and restarting brings it back. It seems to only last a week or so and it goes back to being scrambled. How did you figure out you needed to add an antenna? That's getting down the list! Wait a minute I wanna make sure we are comparing apples to apples. What menu screen of yours is garbled the menu for the TV or the menu for the processor? |
|
