Post by zductive on Apr 14, 2010 13:14:31 GMT -5
When I had completed EMOQ, I noticed that the level for each of my speakers was set to 0. I had previously set the speaker level calibrations using a meter. This is a lot different than the readings used to be.
1 - Should the speaker level settings be set to 0 when you run emoQ?
2 - Is it correct for the emoq1 setting for my mains to be 0 when it takes 6dB in the level adjust window to set them to the correct level?
Interesting that I still have 250 Hz crossover point indicated and a couple of the speakers are said to be reversed. But, the sub level is about 6dB lower than I think that it should be.
interesting - where is the manual?
1 - Should the speaker level settings be set to 0 when you run emoQ?
2 - Is it correct for the emoq1 setting for my mains to be 0 when it takes 6dB in the level adjust window to set them to the correct level?
Interesting that I still have 250 Hz crossover point indicated and a couple of the speakers are said to be reversed. But, the sub level is about 6dB lower than I think that it should be.
interesting - where is the manual?
