|
|
Post by blastermaster on Dec 12, 2012 17:26:50 GMT -5
So I just got my XPA-3 today and man, is it a beast! I am expecting my new front speakers for my HT tomorrow. Do I just plug in the XPA-3 to my receiver, banana plugs into the XPA-3, then run Audyssey and hope all goes well? Soooo excited!
|
|
|
|
Post by The Mad Norseman on Dec 12, 2012 18:55:12 GMT -5
You got that right! Run RCA interconnects from your AVR's preouts to the XPA-3. Then bannana plugs (or bare wire) from the XPA-3 to your speakers, then re-run your AVR's room correction software and it will equalize all channel level outputs, adjust for frequency differences in your speakers, measure distances/delays, and other 'good stuff'!  |
|
