ro919
Minor Hero
Posts: 11
|
Post by ro919 on Dec 22, 2013 20:48:31 GMT -5
Just received my ERC-3, I have it hooked up to Yamaha RS700 cd "in with rca connections. To bypass all the Yamaha internal electronics, can I connect it to the main in coupler, as the coupler out is connected to a xpr-2. Or is there another way so that the receiver is only being used as a volume control, thanks in advance.
|
|
|
|
Post by Andrew Robinson on Dec 22, 2013 20:51:27 GMT -5
Just received my ERC-3, I have it hooked up to Yamaha RS700 cd "in with rca connections. To bypass all the Yamaha internal electronics, can I connect it to the main in coupler, as the coupler out is connected to a xpr-2. Or is there another way so that the receiver is only being used as a volume control, thanks in advance. Connect the ERC-3 to your Yamaha's analog audio in marked (CD or the like) only! Then set your Yamaha's DSP to its "direct" mode or whatever Yamaha chooses to call it. If no direct mode is present than stereo is likely your best bet. Do not connect your CD player to your amp directly! |
|
ro919
Minor Hero
Posts: 11
|
Post by ro919 on Dec 22, 2013 20:57:03 GMT -5
OK Direct mode it is, that's what I've been doing just didn't know if there was any other way. Thanks!
|
|
|
|
Post by novisnick on Dec 22, 2013 20:58:08 GMT -5
Andrew, OP is bypassing internal amps \. Im pretty sure. Ive done this with a RX-1050 and if he just plugs into CD he should be fine.
Nick
|
|
