UPA-200/ RCA connection damage

[cheglie]

I realized my cable connection from my receiver to my amp was just a bit too short, tight and had bent/damaged my RCA connection on the back of the amp. Just enough that it bends slightly in one direction. Looks like it has a small crack at the base. Can't notice in performance. Still sounds the same. However, I'm guessing if I need to detach and attach many more times it could break much worse. Perhaps a replacement RCA part is available that I could install? A little surprised it bent although a tight fit, it seems like it should be a little more durable.



Any suggestions? Would rather DIY than send in to be repaired.