UMC-200 - Can't start EmoQ calibration

[nvr4d]

Hi everyone.

I tried the EmoQ calibration almost two years ago, when I was running plain stereo system.
Since then I got a new home, upgraded my speakers to 5.0 and now trying to re-calibrate the system.

I loaded default settings on my UMC-200, went to Menu => Setup => EMO-Q/EQ and pressed "Emo-Q calibrate". Microphone was connected and it is functional.
So when I press "Emo-Q calibrate", OSD blinks, but nothing else happens.

Is there something I am doing wrong?
Just in case, my FW version is 1.52.02.39.

Thanks in advance!

[drtrey3]

I am certain that you would not make this mistake, but I spent 3 hours with the same problem. It was fixed when I moved the mic from the headphone to the mic jack. As I said, I do not expect anyone but me to make this mistake, but just in case. 8)

Trey

[nvr4d]

Thank you Trey!

This wasn't exactly my case, but plugging-unplugging the mic few times helped
Looks like the microphone jack was too dusty.

Thanks again!

[edisonbaggins]

One unplugging worked for me. Thank you.

[spiette]

Aug 19, 2015 10:12:04 GMT -5 drtrey3 said:

I am certain that you would not make this mistake, but I spent 3 hours with the same problem. It was fixed when I moved the mic from the headphone to the mic jack. As I said, I do not expect anyone but me to make this mistake, but just in case. 8)

Trey

You're not the only one, I've done this several times now since the eyes have gone south. Too bad they didn't use a standard 1/8" headphone jack and it never would be an issue.

[vcautokid]

Well the markings are small on some products. I use the manual to help guide me as my vision on small print isn't so good. Interestingly the UMC-200 manual is not on the main site at least on the resources channel. Try this if you need the manual. www.hifiengine.com/manual_library/emotiva/umc-200.shtml