Post by snafujg on Mar 2, 2016 22:08:58 GMT -5
It's been a long time since I've run Dirac Full, but trying tonight to figure out some things. I'm running Dirac Full on a PC running Windows 10, just upgraded from 8.1 last week. Dirac loads fine and finds my XMC-1. On the next screen where you load the cal file, it automatically loads my cal file, but when I click Proceed, I'm getting the following error:
Failed to initialize device
Device communication failure
PA msg invalid rx byte count; expected 2, got 0
Any ideas? I'm using the EMM-1 Mic and the math cal file. Never had this issue before. Only change is running Windows 10 that I know of. But like I said, it has been probably 6 months since I've run Dirac Full.
Failed to initialize device
Device communication failure
PA msg invalid rx byte count; expected 2, got 0
Any ideas? I'm using the EMM-1 Mic and the math cal file. Never had this issue before. Only change is running Windows 10 that I know of. But like I said, it has been probably 6 months since I've run Dirac Full.
