|
|
Post by jjkessler on Mar 6, 2016 18:59:48 GMT -5
So , I added my new sub (2 identical) where I am running them as dual mono from the XMC. I tweaked some speaker positions and went to rerun Dirac. The level setting tones run fine however, when I am cycling through all of the 9 mic position's I get 3 or 4 into the positions and then my left sub stops generating a test tone. I reset everything 3 times and each time get the level setting tone with no problem but, keeps dropping the left sub test tone and cannot complete the Dirac (full version) run.
Has anybody seen this or have any ideas? I check all cable and that does not seem to be the issue.
|
|
KeithL
Administrator 
Posts: 10,274
|
Post by KeithL on Mar 7, 2016 11:44:48 GMT -5
We haven't heard of that before.... Is it possible that your subs have an auto-on feature and that one is simply turning off. (Even with "identical" units, there can be slight variations i things like the level at which one or the other triggers on, or how long it waits before turning off). If they do have an auto-off feature, I would try both set to "permanently on" and see what happens. So , I added my new sub (2 identical) where I am running them as dual mono from the XMC. I tweaked some speaker positions and went to rerun Dirac. The level setting tones run fine however, when I am cycling through all of the 9 mic position's I get 3 or 4 into the positions and then my left sub stops generating a test tone. I reset everything 3 times and each time get the level setting tone with no problem but, keeps dropping the left sub test tone and cannot complete the Dirac (full version) run. Has anybody seen this or have any ideas? I check all cable and that does not seem to be the issue. |
|
|
|
Post by jjkessler on Mar 7, 2016 13:21:55 GMT -5
I'll give that a try, good idea.
|
|
