XMC-1 and Dirac LE not seeing each other

[lonert]

My network topology is 

ISP -> Netgear (C6300) -> Ethernet Cat5e -> Apple Airport (Extreme/Time Capsule - in Bridge mode) -> DLink Dir555 -> XMC1.

The DLink creates a Network (HT Room Network) within a Network (Home Network).  

The Problem - DHCP request from XMC-1 gets no response from the Netgear (when XMC1 is connected to Home Network) or the Dlink (HT Network). Dirac LE Mac was connected to the same corresponding networks to capture the DHCP packets. 

I have attached two files for the DHCP Discover and Request (captured on the Home Network). I have tried DHCP Reservations on the DLink and the Netgear to no avail.

XMC-1-DHCP-Discover.txt (4.45 KB)
XMC-1-DHCP-Request.txt (4.58 KB)

All other devices have no issue with DHCP allocations. 

TIA for any suggestions/guidance.

I will be more than happy to provide additional information.

TY.

[qdtjni]

Set the address manually.

[lonert]

TY for your suggestion.

I rebooted the entire network and configured a DHCP reservation for the XMC-1 MAC address. There may be a DHCP issue XMC-1, which I will call support about. I was able to see all the devices in Dirac and ran a single measurement and the curve looked reasonable. Played Star Trek Into Darkness and, amidst all the explosions, did not hear any issues. I will run all measurements again and test. Fingers and toes crossed.

I will also test the 105D and 2-Channel.