UMC-200: Cannot set manual EQ separately for SR and SBR

[gerbrand]

All,

This issue has probably already been discussed before, but I failed to find it.

The issue: I am using manual EQ to equalize my loudspreakers. So far I had a 5.1 speaker system and life was great. I was able to set the parametric EQ for all speakers separately. Now I have added two rear surround speakers. I can set the levels, the delays and the x-over separately for the new speakers, but there is no additional set of EQ parameters available for them.  As it turns out the EQ setting for the surround right is effectly used for both the side and back right surrounds (I checked that by measuring using REW, which I also use to determine the settings). The whole story of course applies equally to the left side.

The UMC-200 manual states that EQ setting is possible for all speakers separately, so I think it should be doable. What am I missing?

Thanks for your help,

Gerbrand

[yves]

Unfortunately this cannot be fixed in any way. It is a hardware limitation of the Cirrus DSP platform that the UMC-200 uses.

[bolle]

This is not a hardware limitation. This is simply the way it was (sadly) implemented in the UMC-200 and was never changed / fixed.

[gerbrand]

Thanks for your replies. It looks like it is something I will have to live with then.

Gerbrand