|
|
no sub
Jan 27, 2017 21:07:20 GMT -5
Post by flamethrower1 on Jan 27, 2017 21:07:20 GMT -5
So I have no sub woofer output after running Dirac, if I try to increase the output from the remote, it comes up as no subwoofer.
Do I need to rerun the measurements or am I simply missing something in the speaker preset
|
|
|
|
no sub
Jan 27, 2017 21:28:39 GMT -5
via mobile
Post by gus4emo on Jan 27, 2017 21:28:39 GMT -5
Start from scratch.
|
|
|
|
no sub
Jan 27, 2017 22:45:45 GMT -5
Post by flamethrower1 on Jan 27, 2017 22:45:45 GMT -5
Ran Dirac again, same thing, sounds good but no sub, what am I missing.
|
|
cawgijoe
Emo VIPs 
"When you come to a fork in the road, take it." - Yogi Berra
Posts: 5,033
|
Post by cawgijoe on Jan 27, 2017 23:03:28 GMT -5
Turn the sub on and off if there is a switch. Sometimes the signal from the sub doesn't register. This has happened to me. Does not come out of sleep mode.
|
|
|
|
no sub
Jan 27, 2017 23:46:18 GMT -5
Post by vcautokid on Jan 27, 2017 23:46:18 GMT -5
Just to confirm. Seems I recall before you run Dirac, you need to adjust your levels for each channel. Does the Subwoofer channel register any level before the Dirac Calibration procedure?
|
|
|
|
no sub
Jan 27, 2017 23:49:47 GMT -5
Post by fbczar on Jan 27, 2017 23:49:47 GMT -5
Did you select subwoofer in the menu for the speakers? Maybe it is just not turned on in the preset for Dirac.
|
|
|
|
no sub
Jan 28, 2017 10:38:18 GMT -5
Post by flamethrower1 on Jan 28, 2017 10:38:18 GMT -5
Sub was turned on and it did register test tones when setting the levels before running Dirac.
Sub output is set to mono in the Dirac menu,
Works fine from the other two presets
|
|
