|
|
Post by erikfed on Feb 23, 2017 21:24:57 GMT -5
I go into the menu and have the usual headers... Input, Mode, Trims, Zone, Setup. I cannot access Setup though it skips right over it. Moving left to right at the top I go from Zone and cycle right back to Input skipping right over Setup? Please help.
|
|
|
|
Post by doc1963 on Feb 23, 2017 22:13:10 GMT -5
I go into the menu and have the usual headers... Input, Mode, Trims, Zone, Setup. I cannot access Setup though it skips right over it. Moving left to right at the top I go from Zone and cycle right back to Input skipping right over Setup? Please help. See my response to the same issue in THIS thread. Hope it helps you too.....  |
|
|
|
Post by Soup on Feb 24, 2017 8:44:51 GMT -5
Solution from other post.......... Sounds like you've accidentally locked yourself out of the Setup menu. Does the Menu button on the front panel respond...? I don't remember how it works for the UMC-200 (and the manual doesn't mention it), but you can try this from the XMC-1 the manual..... "If you find yourself in this situation, you may still access the setup Advanced Menu directly by pressing the MENU button on the front panel while holding down the front panel ENTER button." Once you finally get in, go to the "Advanced" setup menu and make sure that "Lock" is set to "None" or "Off" Hope this helps..... |
|
