davidcw (account pending bs)
Guest
|
Post by davidcw (account pending bs) on Nov 22, 2017 9:14:18 GMT -5
I'm controlling my MC-700 via it's RS-232 serial port. A iTach IP2SL with a straight-through serial cable works fine, I can send commands over IP -> serial and the MC-700 responds as it should. The list of supported serial commands is downloadable in a Word document, version 1.6 has the serial codes. But, when you send a code to the MC-700 it responds, it returns codes back according to what you sent it or what it did. Is there is a list anywhere of what these codes are and what they mean, so I can handle the response from the MC-700 correctly? Anyone know? Thanks!
|
|
LCSeminole
Global Moderator 
Res firma mitescere nescit.
Posts: 20,490
|
Post by LCSeminole on Nov 22, 2017 10:42:20 GMT -5
I'm controlling my MC-700 via it's RS-232 serial port. A iTach IP2SL with a straight-through serial cable works fine, I can send commands over IP -> serial and the MC-700 responds as it should. The list of supported serial commands is downloadable in a Word document, version 1.6 has the serial codes. But, when you send a code to the MC-700 it responds, it returns codes back according to what you sent it or what it did. Is there is a list anywhere of what these codes are and what they mean, so I can handle the response from the MC-700 correctly? Anyone know? Thanks! You’ll need to call Emotiva for this I would think. |
|
