|
|
Post by florencephile on Dec 24, 2018 15:42:39 GMT -5
Mac laptop with latest OS updates
Xmc with new v3 board and latest stable firmware.
What happens:
I run the dirac software, all seems well, go to save or download to the xmc, again all seems well ( xmc showing downloading ).
After a few minutes, the xmc just goes back to normal and dirac software closes on my laptop, no confirmation that it worked or finished etc...
No idea if it sent my config. Any thoughts anyone?
|
|
|
|
Post by florencephile on Dec 27, 2018 8:47:53 GMT -5
No one have this ever?
|
|
|
|
Post by florencephile on Jan 20, 2019 17:05:59 GMT -5
Anyone have any thoughts?
|
|
|
|
Post by creimes on Jan 20, 2019 18:36:44 GMT -5
No clue, I've had a couple of hang ups where I needed to restart Dirac but no drops like you talk of, I say reset all your network gear and devices(laptop and XMC-1) getting everything with refreshed IP addresses.
|
|
|
|
Post by enricoclaudio on Jan 21, 2019 20:05:14 GMT -5
Mac laptop with latest OS updates Xmc with new v3 board and latest stable firmware. What happens: I run the dirac software, all seems well, go to save or download to the xmc, again all seems well ( xmc showing downloading ). After a few minutes, the xmc just goes back to normal and dirac software closes on my laptop, no confirmation that it worked or finished etc... No idea if it sent my config. Any thoughts anyone? It happened to me a few times. My guess is that your are using a MacBook Pro, right? If yes, save your Dirac project after every measurement and also before sending the filters to the XMC-1. If you didn't save the project before sending it to the XMC-1, then you need to start over. With the Dirac project saved, try again sending it to the XMC-1 and on the second attend the XMC-1 will show you that the filters were downloaded successfully. |
|
|
|
Post by wilburthegoose on Jan 22, 2019 7:43:37 GMT -5
On Windows 10, I need to run Dirac from an local account with full admin rights.
Have you considered buying a cheap/used Windows PC?
|
|
|
|
Post by florencephile on Jan 22, 2019 11:26:57 GMT -5
Mac laptop with latest OS updates Xmc with new v3 board and latest stable firmware. What happens: I run the dirac software, all seems well, go to save or download to the xmc, again all seems well ( xmc showing downloading ). After a few minutes, the xmc just goes back to normal and dirac software closes on my laptop, no confirmation that it worked or finished etc... No idea if it sent my config. Any thoughts anyone? It happened to me a few times. My guess is that your are using a MacBook Pro, right? If yes, save your Dirac project after every measurement and also before sending the filters to the XMC-1. If you didn't save the project before sending it to the XMC-1, then you need to start over. With the Dirac project saved, try again sending it to the XMC-1 and on the second attend the XMC-1 will show you that the filters were downloaded successfully. I am on a MBpro, I will give that a shot, thanks |
|
