|
Post by rdavidw on Apr 13, 2020 14:15:19 GMT -5
I have had my MC-700 for about a year and have not had any problems with it. I recently canceled my cable TV and got a bunch of Roku devices. Don't have any problems with it on my XMC-1 or my other older receiver. The MC-700 worked fine the first few times I used it with the Roku and then when I powered it on I got a . . . Loading . . . . screen. I waited for an hour and then powered it off and waited a few min and then powered it back on. Got the same loading screen. I googled it and found this: www.youtube.com/watch?v=91SBqFXmtDMIn the comments someone posted "Roku has come out with a new update which is creating this issue in Emotiva, so please disconnect it and check, Thanks" I disconnected the HDMI from the Roku Ultra and powered the MC-700 on and it booted up fine. I then, while set to a different input, plugged the Roku in and then selected that input and it worked fine. I then powered the MC-700 off and on again with everything plugged in and got the Loading error again. I also found this but it seems less relevant: emotivalounge.proboards.com/thread/41827/umc-infinitive-loading-after-power Is there an update available for the MC-700 that fixes this? I plugged the Roku into a relay that is connected to a trigger out on one of the amps. When the system is turned off the Roku looses power and when it is turned on there is a bit of a delay for the Roku to boot up so I am not getting the loading error so far. Not ideal but may be a work around.
|
|
|
Post by rbk123 on Apr 13, 2020 16:37:34 GMT -5
Not aware of the issue or if there is a fix, you'd have to call Emo. However, which inputs have you tried the Roku with? Both the 1.4 HDMI input and the 2.0a inputs? Do you get the same behavior with each?
I don't have any Roku's hooked up to my MC700 but have an Ultra upstairs I could grab and try it if you'd like.
|
|