|
|
Post by lhracing on Dec 11, 2020 20:17:37 GMT -5
I have ran Dirac a number of times and never had any problems. I made some setup changes and reran Dirac and now I get a popping noise from the Right subwoofer only. The pop happens when the processor is turned on or off and when the volume is turned up or down with both the remote and front panel control. The pop only happens with the Dirac preset, Preset 1 and 2 function as normal.
Any else had similar problems?
|
|
ttocs
Global Moderator 
I always have a wonderful time, wherever I am, whomever I'm with. (Elwood P Dowd)
Posts: 8,170
Member is Online
|
Post by ttocs on Dec 11, 2020 21:01:59 GMT -5
No pops for me. Which version of Dirac?
Can you run REW to see what shows up? Be careful, and set the gain low so there's no surprises.
|
|
|
|
Post by lhracing on Dec 11, 2020 23:22:33 GMT -5
After looking closer, the right sub had the popping noise but neither sub had any output when in the Dirac preset but both worked when using preset 2. I shut down the Processor and disconnected the power cord, then restarted with a clean reboot and everything is working as it should. Redoing the Dirac must have left the processor in a defective or confused state.
|
|
