XMC2 error init EDA2

[rxw]

Ever since new my XMC2 has displayed the below error message.

___

I use low power mode and almost every single cold boot it errors out and needs to be manually reset either by power cycling or holding power for 5+ seconds. I need to use low power mode due to the confined space the unit is in as I don't want fans running 24/7.

I'm using the latest firmware, does anyone else experience this error regularly or know the cause/remedy?

[bender6502]

I know this message is old, but I've been getting this message on my XMC-2 as well. I too use cold boot (lowest power setting). I've got this message on firmware 3.1. I recently updated to 3.2, but it hasn't gone away. It only happens, every so often.

Have you found a remedy for this?

[rshank64]

I've been getting this message on my
RMC-1 as well. I too use cold boot only (lowest power setting). I've got this message on firmware 3.2.It only happens occasionally. The system locks up and only way to start again is by pressing and holding the front power button!

This appears to be a bug and if everyone reports it on this thread then Emotiva may look into it!!

[ttocs]

Aug 25, 2023 9:18:49 GMT -5 rshank64 said:

I've been getting this message on my
RMC-1 as well. I too use cold boot only (lowest power setting). I've got this message on firmware 3.2.It only happens occasionally. The system locks up and only way to start again is by pressing and holding the the front power button!

This appears to be a bug and if everyone reports it on this thread then Emotiva may look into it!!

If it happened only once, it was probably just a glitch. If it happened more than once, send it in for repair. Contact Emotiva and send it in for repair, they will fix the issue.

I had a different err:, Emotiva Service re-flashed a board and solved the issue. I sent the processor out on Monday, got it back on Saturday.