New owner of XPR-1 mono block amps-Question?

[todd1010]

I received one of the two monster boxes today from the seller and being OCD, I wanted to clean it a little even though it was in immaculate condition.

After opening the top case I noticed the transformer was loose, is this on purpose or should I tighten it up from the bottom?

Also, there was a couple screws missing and I wanted to replace them. Anyone have a place to buy some small black machine screws?

[garbulky]

Sometimes the transformers make a clicking sound on warming up. Loosening the screws just a half turn stops this from happening. But if the screws are like fully loose then this situation isn't the same thing.

[todd1010]

Actually it’s pretty darn loose and I’d prefer to tighten it up.

Does anyone know how to access the bolt to tighten the transformer up?

[todd1010]

I got the transformer tightened all back down. You have to remove the front display and there is a 19mm nut that holds it down.

[leonski]

May 4, 2021 16:54:43 GMT -5 todd1010 said:

I got the transformer tightened all back down. You have to remove the front display and there is a 19mm nut that holds it down.

Powered it UP yet?   Any noise from the transformer?