|
|
Post by creimes on May 30, 2021 10:52:34 GMT -5
My XMC-1's network connection will not work, I have tried all the resets and such but still no go, opening up the top cover i notice reset buttons on some of the individual component boards inside including the network board, has anyone tried these ?? or is it something I can even do haha, I miss being able to control the volume for zone 2 on my iPad while outside, a real PITA and this XMC-1 doesn't have warranty or in my name so no trade in possible.
Cheers,
Chad
|
|
ttocs
Global Moderator 
I always have a wonderful time, wherever I am, whomever I'm with. (Elwood P Dowd)
Posts: 8,170
Member is Online
|
Post by ttocs on May 30, 2021 12:43:07 GMT -5
Shooting in the dark with this one, but, a go-to troubleshooting step is to save your settings, do a Factory Reset, then a cold boot with at least one minute of off time.
|
|
|
|
Post by creimes on May 30, 2021 15:07:23 GMT -5
Shooting in the dark with this one, but, a go-to troubleshooting step is to save your settings, do a Factory Reset, then a cold boot with at least one minute of off time. Yeah I've tried that few times now  |
|
|
|
Post by spom409 on May 31, 2021 8:53:55 GMT -5
I've experienced this a few times. You can try this.
Disconnect your LAN/Network cable from the unit.
Turn off the XMC-1. Turn it on and watch the progress bar as it boots up.
When it gets to approximately 50%, plug the cable back in. Try searching for the unit on the IPAD.
I hope that helps.
|
|
|
|
Post by creimes on May 31, 2021 9:22:45 GMT -5
I've experienced this a few times. You can try this. Disconnect your LAN/Network cable from the unit. Turn off the XMC-1. Turn it on and watch the progress bar as it boots up. When it gets to approximately 50%, plug the cable back in. Try searching for the unit on the IPAD. I hope that helps. Will give it a try thanks, I need to go into settings and take a pic to post, if I remember correctly it has seem to have locked up IP info, at work though so can't check it now  |
|
