|
|
Post by pdasterly on Sept 25, 2021 16:10:32 GMT -5
Xpa-5 gen 1, one of my channels pops when I power off system, switched around rca cables and it’s isolated to one channel of the amp. System plays perfectly other than the loud pop when I turn off
|
|
|
|
Post by thompson12 on Sept 25, 2021 17:08:15 GMT -5
My XPA-5 starting popping through the speakers when powering off after an MXC-2 firmware update but then stopped popping after the next update. Maybe an equipment issue?
Mitch
|
|
|
|
Post by pdasterly on Sept 25, 2021 17:44:53 GMT -5
My XPA-5 starting popping through the speakers when powering off after an MXC-2 firmware update but then stopped popping after the next update. Maybe an equipment issue? Mitch Mine is powered by yamaha avr rx-a2060. |
|
|
|
Post by 405x5 on Sept 26, 2021 8:29:03 GMT -5
Hope you solve that one.
With my old Carver Amps. I would get some capacitor discharge noise to the speakers but it was a normally occurring glitch
|
|
|
|
Post by DavidR on Sept 26, 2021 9:25:15 GMT -5
Try this and see if it makes a difference.
ON/OFF Sequence
ON: PreAmp, Source, AMP
OFF: AMP/Source/Pre
|
|
