|
|
Post by Ray D on Sept 27, 2021 16:35:22 GMT -5
Just purchase a XMC-1 Refurbished and I am having the same issue that I did with the XMC-2 that I sent back two years ago. It requires that the entire system be turned on then the DirecTv box last inorder for the video to show up. Audio is not a problem. It is only the Directv box. This can be done manually but there must be a one button solution. Using a Harmony One remote.
Anyone?
Thanks
Ray D
|
|
|
|
Post by donh50 on Sept 27, 2021 19:43:46 GMT -5
I set the delay parameters in my Harmony One. The units are ms so I entered a pretty big number, like 10,000, for a 10-second delay.
|
|
|
|
Post by Ray D on Sept 28, 2021 6:26:58 GMT -5
I tried 8,000 on the power on time for the Directv box but it was not slowed down it still fires up immediately.
|
|
|
|
Post by Ray D on Sept 28, 2021 6:29:50 GMT -5
I also tried leaving the Directv box on "all the time" and the XMC-1 still would not latch on to the video everytime.
|
|
|
|
Post by AudioHTIT on Sept 28, 2021 15:26:01 GMT -5
Just purchase a XMC-1 Refurbished and I am having the same issue that I did with the XMC-2 that I sent back two years ago. It requires that the entire system be turned on then the DirecTv box last inorder for the video to show up. Audio is not a problem. It is only the Directv box. This can be done manually but there must be a one button solution. Using a Harmony One remote. Anyone? Thanks Ray D I no longer have an XMC-1, but do have an RMC-1 and a DirecTV C61K client. I’m able to get video consistently and do use a Harmony Elite Home Remote. As a test, can you try to assign one of the ‘Buttons’ (1-7) to the DirecTV input, and after everything else has settled press that — on your Harmony it should either be called Input X (say 1), or just 1. Or try the Emotiva remote. |
|
|
|
Post by Ray D on Sept 29, 2021 6:31:14 GMT -5
It was the #1 input on the XMC-1 that was the problem. Move to the #2 input issue gone.
|
|
