|
|
Post by Goodfella on Dec 17, 2023 18:38:35 GMT -5
Hello,
I would like to boost my center channel about 2db. Can you boost a speaker channel volume when doing a Dirac calibration? Is there a better way to do this on the XMC2?
Thanks.
|
|
|
|
Post by geebo on Dec 17, 2023 18:49:27 GMT -5
Hello, I would like to boost my center channel about 2db. Can you boost a speaker channel volume when doing a Dirac calibration? Is there a better way to do this on the XMC2? Thanks. You can go into the speaker levels after running Dirac and adjust the individual speaker levels any way you want. Any levels set there will be added to the Dirac results whether they were set before or after running Dirac so it's best to start with all levels set to zero then adjust relative levels as desired. You could also set the target curve in Dirac for the center channel 2db higher across the board but doing in in Levels in Speaker Setup is much easier. |
|
|
|
Post by Goodfella on Dec 18, 2023 10:59:59 GMT -5
You are talking about the XMC2 setting levels for each speaker, correct? Not something in Dirac.
|
|
|
|
Post by jbncccb on Dec 18, 2023 17:08:58 GMT -5
You are talking about the XMC2 setting levels for each speaker, correct? Not something in Dirac. No, he is referring to the setting in Dirac. Once Dirac levels are set the XMC levels are no longer used. Dirac over rides them I believe. |
|
